Research on the Failure Characteristics of a Spherical Bearing

Strength of Materials - In order to study the failure process of a large-scale spherical bearing, the finite element simulation method was used to establish the full-scale finite element model of...     

Special Issue on the Internet of Things (ISCC 2020)

Journal of Signal Processing Systems -     

Microstructure and mechanical behavior of laser aided additive manufactured low carbon interstitial Fe49.5Mn30Co10Cr10C0.5 multicomponent alloy

Laser aided additive manufacturing(LAAM)was used to fabricate bulk Fe49.5Mn30Co10Cr10C0.5 interstitial multicomponent alloy using pre-alloyed powder.The room temperature yield strength(σy),ultimate tensile strength(σUTS)and elongation(εUST)were 645 MPa,917 MPa and 27.0％respectively.The as-built sample consisted of equiaxed and dendritic cellular structures formed by elemental segregation.These cellular structures together with oxide particle inclusions were deemed to strengthen the material.The other contributing components include dislocation strengthening,friction stress and grain bound-ary strengthening.The high εUTS was attributed to dislocation motion and activation of both twinning and transformation-induced plasticity(TWIP and TRIP).Tensile tests performed at-40℃and-130℃demonstrated superior tensile strength of 1041 MPa and 1267 MPa respectively.However,almost no twinning was observed in the fractured sample tested at-40℃and-130℃.Instead,higher fraction of strain-induced hexagonal close-packed(HCP)ε phase transformation of 21.2％were observed for fractured sample tested at-40℃,compared with 6.3％in fractured room temperature sample.     

The structure,vacancy characteristics,and magnetic properties of GdMn1-xCrxO3 ceramics

To investigate the evolution of the structural and enhanced magnetic properties of GdMnO₃ systems induced by the substitution of Mn with Cr, polycrystalline GdMn_1-xCr_xO₃ samples were synthesized via solid-state reactions. XRD characterization shows that all GdMn_1-xCr_xO₃ compounds with single-phase structures crystallize well and that Cr³⁺ ions entering the lattice sites of GdMnO₃ induce structural distortion. SEM results indicate that the grain size of the synthesized samples (a few microns) decreases as the Cr substitution concentration increases. Positron annihilation lifetime spectroscopy reveals that vacancy-type defects occur in GdMn_1-xCr_xO₃ ceramics and that the vacancy size and concentration clearly change with the Cr content. The temperature and field dependence of the magnetization curves show that Cr substitution significantly influences the magnetic ordering of the gadolinium sublattice, improving the weak ferromagnetic transition temperature and magnetization of GdMn_1-xCr_xO₃. The enhanced magnetization of GdMn_1-xCr_xO₃ is closely related to the vacancy defect concentration.     

Cell-Permeable Succinate Rescues Mitochondrial Respiration in Cellular Models of Statin Toxicity

Statins are the cornerstone of lipid-lowering therapy. Although generally well tolerated, statin-associated muscle symptoms (SAMS) represent the main reason for treatment discontinuation. Mitochondrial dysfunction of complex I has been implicated in the pathophysiology of SAMS. The present study proposed to assess the concentration-dependent ex vivo effects of three statins on mitochondrial respiration in viable human platelets and to investigate whether a cell-permeable prodrug of succinate (complex II substrate) can compensate for statin-induced mitochondrial dysfunction. Mitochondrial respiration was assessed by high-resolution respirometry in human platelets, acutely exposed to statins in the presence/absence of the prodrug NV118. Statins concentration-dependently inhibited mitochondrial respiration in both intact and permeabilized cells. Further, statins caused an increase in non-ATP generating oxygen consumption (uncoupling), severely limiting the OXPHOS coupling efficiency, a measure of the ATP generating capacity. Cerivastatin (commercially withdrawn due to muscle toxicity) displayed a similar inhibitory capacity compared with the widely prescribed and tolerable atorvastatin, but did not elicit direct complex I inhibition. NV118 increased succinate-supported mitochondrial oxygen consumption in atorvastatin/cerivastatin-exposed platelets leading to normalization of coupled (ATP generating) respiration. The results acquired in isolated human platelets were validated in a limited set of experiments using atorvastatin in HepG2 cells, reinforcing the generalizability of the findings.     

A Quest for (sila)0-4cyclopentasilylenes and their Arduengo Analogs by DFT

Silicon - Following our interest in exotic silylenes, here we compare and contrast 20 novel five-membered cyclic silylenes, including saturated (sila)0–4 cyclopentasilylenes (1–10) and...     

Photoluminescence of Gallate Glass-Ceramics: Al2O3 Influence

Glass and Ceramics - The influence of Al2O3 as an additive and the heat-treatment regime on the luminescence spectra of gallate glass-ceramics was investigated. It is shown that its luminescence...     

Interfacial microstructure and mechanical properties of Ti3SiC2 ceramic and TC11 alloy joint diffusion bonded with a Cu interlayer

Reliable joints of Ti₃SiC₂ ceramic and TC11 alloy were diffusion bonded with a 50 μm thick Cu interlayer. The typical interfacial structure of the diffusion boned joint, which was dependent on the interdiffusion and chemical reactions between Al, Si and Ti atoms from the base materials and Cu interlayer, was TC11/α-Ti + β-Ti + Ti₂Cu + TiCu/Ti₅Si₄ + TiSiCu/Cu(s, s)/Ti₃SiC₂. The influence of bonding temperature and time on the interfacial structure and mechanical properties of Ti₃SiC₂/Cu/TC11 joint was analyzed. With the increase of bonding temperature and time, the joint shear strength was gradually increased due to enhanced atomic diffusion. However, the thickness of Ti₅Si₄ and TiSiCu layers with high microhardness increased for a long holding time, resulting in the reduction of bonding strength. The maximum shear strength of 251 ± 6 MPa was obtained for the joint diffusion bonded at 850 °C for 60 min, and fracture primarily occurred at the diffusion layer adjacent to the Ti₃SiC₂ substrate. This work provided an economical and convenient solution for broadening the engineering application of Ti₃SiC₂ ceramic.     

Structural,electronic paramagnetic resonance and magnetic properties of praseodymium-doped rare earth CeO2 semiconductors

In this work, praseodymium (Pr) doped cerium oxide (CeO₂) was prepared using the microwave-assisted hydrothermal method (MAH) and the properties were investigated by X-ray diffraction analysis (XRD), Raman spectroscopy, Field Emission Gun Scanning Electron Microscope (FEG-SEM), BET method, Photoluminescence spectroscopy (PL), Fourier-transform infrared spectroscopy (FTIR), Ultraviolet–visible spectroscopy (UV–Vis), Electron paramagnetic resonance spectroscopy (EPR) and Magnetometry. The results showed that increasing the Pr-doping promotes a structural disorder due to increased oxygen vacancies. XRD confirmed a cubic structure without deleterious phases with modifications in the structure caused by alteration in the cerium oxidation state as well as changes in the crystallite size and strain obtained by Wellinson-Hall method. Raman spectroscopy shows that changing the Pr content results in samples with different defect densities at short range. FEG-SEM showed that the nanocrystals are agglomerated with small particles tend to aggregate spontaneously to decrease the surface energy. BET method showed that the Pr doping results in a gain of specific surface area. PL indicated that Pr³⁺ leads to distinct emissions; red emission associated to oxygen vacancies located near the conduction band (shallow defects), green emission associated to electron-hole recombination and orange emission associated to shallow defects and electron-hole recombination. FTIR indicated the complete process of nucleation with no other phase. UV–Vis showed the transitions between oxygen 2p, cerium 4f and praseodymium 4f states. The EPR signal shows events occurring around 344 mT. These events can be related due the presence of paramagnetic elements containing unpaired electrons, such as Ce (III), which is indicative of cerium reduction caused by Pr ions, as evidenced by Rietveld data. Regardless of the Pr concentration used in this research, the magnetic measurements show a superparamagnetic system below the blocking temperature of ~20 K and a paramagnetic system above this temperature, which indicates no significant changes in the average size of the nanoparticles. Surface area, crystallite size and the temperature are important parameters, which control the magnetic properties of such N-type semiconductors.